SNOX™ technology

Reduce flue gas emission compliance costs in refineries and power plants

With our SNOX™ technology, refineries and power plants can remove sulfur dioxide, nitrogen oxides, and particulates from flue gases. The sulfur is recovered in the form of commercial-grade concentrated sulfuric acid, and the nitrogen oxides are converted to harmless free nitrogen. Combustible particulates like soot are burned in contact with the catalyst in the SNOX™ unit. Other particulates are separated and made available as a dry powder, without polluting any byproducts.

Taking on the challenges of FGD
Conventional flue gas desulfurization (FGD) methods are plagued by high operating costs, massive limestone consumption, and production of contaminated gypsum that must be deposited. This makes conventional FGD’s increasingly expensive to operate, particularly as fuel sulfur content increases.

SNOX™ takes on these challenges by combing the removal of SOx, NOx, and particulates with commercial-grade sulfuric acid production. This unique process significantly reduces the costs associated with compliance. It also eliminates waste and material logistics, consumes no water or reagents for the desulfurization, and creates a cost-effective alternative to traditional FGD.

Because of the high energy-efficiency of a SNOX™ unit, a boiler, combustor or power plant equipped with SNOX™ will typically achieve an improved energy effectiveness of 5%, which means a drop in specific CO₂emissions of a similar percentage. Unlike the use of limestone, the SNOX™ flue gas cleaning process does not, in itself, emit CO₂.

The SNOX™ process

工作原理
The SNOX™ process includes the following steps:

• Dust is removed using electrostatic precipitators or bag filters. Any residual dust will be trapped in the SO₂conversion catalyst, from where it can be removed periodically. (If the dust is combustible, as is the case with soot, dust removal is not required, since the dust will be burned in contact with the catalyst in the SO₂converter.)
• Catalytic reduction of NOx takes place by adding NH₃to the gas upstream of the SCR DeNOx converter.
• Catalytic oxidation of SO₂to SO₃takes place in the oxidation converter.
• 气体在WSA冷凝器中冷却至约100°C，使SO₃to combine with water vapor to form sulfuric acid vapor that condenses and is withdrawn as a commercial grade concentrated sulfuric acid product.
• The gas can now be sent to stack freed of its sulfur dioxide, NOx, and particulate content.
• Air that has been used for cooling in the WSA condenser is returned to the boiler, combustor, power plant or other source of the flue gas, where it can be used as preheated combustion air.